Pre-filter cleaning – Kenmore ASPIRADORA 116.31591 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PRE-FILTER CLEANING

The pre-filter is located inside the dust

bin. Check the pre-filter frequently and

clean when dirty.

NOTE: If necessary, the pre-filter can be

removed to be cleaned with water.

1. Remove the dust bin as outlined in the

DUST BIN EMPTYING section. Refer to

page 17.

2. Rotate dust bin

lid from lock to

unlock position.

S.Separate dust bin lid

by pulling down and
lift off.

4. Remove

retaining ring

by turning in

direction as

indicated by

arrow.

Retaining

ring

5. Remove pre

filter by sliding
downward.

Pre-filter

6. Clean pre-filter

by gently tapping

over a trash
container. Tap on
several sides to
ensure best
cleaning.

Pre-Filter

7. Rinse with cold water only, DO NOT
use detergent or soap. Allow parts to dry

24 hours before putting back into vacuum
cleaner.

DO NOT wash pre-filter in the

dishwasher.

DO NOT install parts damp.

TO REPLACE PRE-FILTER

1. Slide pre

filter upward
onto dust bin

lid body. Align
large tab with
large slot.

2. Slide

retaining ring
into position.

Align large tab
with large slot.

Rotate as

indicated by

arrow.

3. Replace the lower

portion of the dust bin

by aligning marks as
UNLOCKED.

4. Rotate until marks
align as LOCKED.

5. Replace the dust bin

as outlined in the

Replace Dust Bin

section. Refer to page