Kenmore 3948597B - Manual (Page 5)

Electrical ReqyirBnients
AWARNING
>8
Electricai Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A 120-volt, 60-Hz., AC-only, 15- or 20-ampere, fused
electrical supply Is required. Time-delay fuse or circuit
breaker Is recommended. It Is recommended that a separate
circuit serving only this appliance be provided.
This v\/asher is equipped with a power supply cord having a 3
prong ground plug.
To minimize possible shock hazard, the cord must be
plugged into a mating, 3 prong, ground-type outlet, grounded
in accordance with local codes and ordinances. If a mating
outlet is not available, it is the personal responsibility and
obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sur
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
1. 3 prong grounding plug
2. 3prong grounding-type outlet
3. Ground prong
4. Power supply cord
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a mal­
function or breakdown, grounding wili reduce the risk
of electrical shock by providing a path of least resist­
ance for electric current. This washer is equipped with
a cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and ground­
ed in accordance with all local codes and ordinances.
WARNING: improper connection of the equipment­
grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman
if you are in doubt as to whether the appliance is prop­
erly grounded.
Do not modify the plug provided with the appliance -
if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead
on the appliance.
INSTALLATION
it is
that the
INSTRUCTIONS
the Before Ybii Start
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
To prevent floor damage, set the washer onto cardboard
before moving across floor.
Move the washer to within approximateiy 3 ft (90 cm) of the
finai iocation.