Important safety notice, Important safety instructions, Grounding instructions – Kenmore 790.7754 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Grounding type
wall receptacle
Grounding instructions
(electric ignition models only)
important Safety instructions
Do not, under any
circumstance, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong
grounding plug
ià WARNING
I
Avoid fire hazard or electrical shock. Do not use an adapter plug,
an extension cord, or remove grounding prong from electrical power cord.
Failure to follow this warning can cause serious injury, fire or death.
WARNING
This appliance is equipped with a 3-prong grounding plug for
your protection against shock hazard and should be plugged directly into a
properly grounded receptacle.
DO NOT
cut or remove the grounding prong from
this plug.
For personal safety, the range must be properly grounded. For maximum safety,
the power cord must be plugged into an electrical outlet that is correctly polarized
and properly grounded.
If a 2-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded 3-
prong wall receptacle installed by a qualified electrician.
See the
INSTALLATION INSTRUCTIONS
packaged with this range for complete
installation and grounding instructions.
Important Safety Notice
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances
known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of
potential exposure to such substances.
Conversion to Liquefied Petroleum Gas (or L.P. Gas)
(Some models)
Please Note:
Models equipped with a double right
front gas burner are not L.P. Convertible. (Some models) All other
models are designed to allowfor conversion to Liquefied Petroleum
(L.P.) Gas.
If L.P. conversion is needed and possible for your model, contact
your local L.P. gas provider
for assistance. The L.P. Conversion
Kit will be provided with this range and is located on the left lower
REAR (back side) panel of the range. Before installing the kit be
sure to follow the L.P. Installation Instructions carefully.
iiWARNING
Personal injury or death from
electrical shock may occur if the range is not
installed by a qualified installer or electrician.
AWARNING
j
Any additions, changes or
conversions required in order for this appliance to
satisfactorily meet the application needs must be
made by Sears Service.