Outside hole inside hole – Kenmore 16238 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
14. Position ieft side shelf over shelf mounting brackets
15. To begin installation be sure to align iarge shelf (holes) with the small holes in
the shelf bracket assembly. Insert (2) #10 x 1/2” Truss head screws (phillips drive)
into largest hole on outside rear corner of shelf carefully aligning with small hole in
shelf mounting bracket. Repeat procedure for inside rear.
Outside hole
Inside hole
^ Rear View
16. To install shelf trim, tilt grill onto opposite shelf supports, align large
holes in shelf bracket and shelf witht the small holes in the shelf trim. Then
place (2) #10
X
1/2” truss head screws into larger holes first (underneath
shelf) and tighten securely.
Front View
17. After securing shelf trim to shelf/shelf bracket, align large hole on inside
flange with large hole in control console and small hole in casting support
bracket and insert (1) #10 x 1/2” truss head screw.
N
S
13