Surface cooking, Operating the gas surface burners, Setting proper surface burner flame size – Kenmore ELITE 790.7943 User Manual
Page 11: Before first use, After each use, Using the griddle, Size
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Surface Cooking
•
Operating Gas Surface Burners
•
Setting Proper Burner Flame Size
•
Griddle Accessory
ikCAUTION
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top
of
the range when it is in use.
These items could melt or ignite. Potholders, towels or wood spoons could catch fire
if placed too close to a flame.
Operating
the
Gas Surface Burners:
1. Place cooking utensil on surface burner.
2. Push the knob in and turn
counterclockwise
out of the OFF position (See
Fig. 1).
3. Release the knob and rotate to the LITE position. Note: All four electronic
surface ignitors will spark at the same time. However, only the burner you
are turning on will ignite.
/
4. Visually check that the burner has lit.
j
5. Push the control knob in and turn
counterclockwise
to the desired flame
size. The control knobs do not have to be set at a particular setting. Use the
guides and adjust the flame as needed.
DO NOT
cook with the surface
\
control knob in the LITE position (The electronic ignitor will continue to spark \
if the knob is left in the LITE position).
"
Setting Proper Surface Burner Flame
Size
The size and type of utensil used and the amount of food being cooked will
influence the setting needed for cooking.
Fig.1
Flame Size
Typeof Cooking
High Flame
? Start most foods; bring water to a boil; pan broiling.
Medium Flame
j Maintain a slow boil; thicken sauces, gravies; steaming.
Low Flame
s Keep foods cooking; poach; stewing.
Always select cookware that is suitable for the amount and type of food being prepared.
Select a burner and flame size appropriate to the pan. Never allow flames to extend
beyond the outer edge of the pan.
Care & Seasoning of the Griddle (optional accessory)
Before first use:
• Wash Griddle in hot soapy water. Rinse and then dry completely.
•Apply a thin coat of vegetable oil to the entire surface (front and back of griddle).
• Preheat your oven to
350°F
. Place the griddle on the upper rack in your oven.
• Bake griddle for 1 hour at 350°F, then turn oven OFF and let cool before removing.
• The surface may appear to have a tacky feel to it from the seasoning process. If desired, wash
the griddle in hot soapy water, rinse well, and dry completely.
After each use:
• To prevent rusting, store in a dry place and keep uncovered.
•After each use, clean with a stiff brush and hot water only.
• DO NOT CLEAN
GRIDDLE
IN DISHWASHER.
• Dry Immediately and apply a light coating of vegetable oil to griddle before storing.
Using the Griddle:
• Place either side of the griddle centered over the left side gas burners or over the Bridge Burner
(some models). For location refer to Fig. 1.
• Preheat the griddle for 5 minutes on medium to medium low setting. Slow preheat ensures even
heat distribution during the cooking process.
• DO NOT preheat the griddle on HI setting. Preheating on HI may warp the griddle and prevent
even heat distribution.
Proper
flame size
V k J
J Improper
flame size
Fig. 2
|-r|
:v
F ig.3
11