beautypg.com

Caution: beware of flashback, Flashback prevention, A warning – Kenmore ELITE 141.1668 User Manual

Page 5: Tools required for assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CAUTION: BEWARE OF FLASHBACK

CAUTION: Spiders and small insects occa­
sionally spin webs or make nests in the grill

Burner Tubes during transit and warehousing.

These webs can lead to a gas flow obstruc­
tion which could result in a fire in and around
the Burner Tubes. This type of fire is known

as a "FLASHBACK" and can cause serious

damage to your grill and create an unsafe

operating condition for the user.

To reduce the chance of "FLASHBACK", you
must clean the burner tubes before assem­

bling your grill, and at least once a month in

late summer or early fall when spiders are
most active. Also perform this Burner Tube
cleaning procedure if your grill has not been

used for an extended period of time.

Flashback Prevention

To reduce the chance of "FLASHBACK" (see
CAUTION at right) clean the Burner Tubes and

Burners before fully assembling your grill.
Remove the Cotter Pin from the rear underside

of each Burner using a pair of long nose pliers.
Carefully lift each Burner up and away from the

Gas Valve Orifice, then refer to Figure 1 and
perform one of these three cleaning methods:

1, Bend a stiff wire, (a lightweight coat hanger

works well) into a small hook as shown
below. Run the hook through the Burner Tube
and inside the Burner several times to remove
any debris.

C

2

.

3.

Use a bottle brush with a flexible handle.
Run the brush through the Burner Tube and
inside the Burner several times, removing any
debris.

Use an air hose to force air through each

Burner Tube. The forced air should pass

debris or obstructions through the Burner and
out the Ports.

Figure 1

A WARNING

The location of the Burner Tube with re­

spect to the Orifice is vital for safe

operation. Check to ensure the Orifice is

inside the Burner Tube before using your

gas grill. See Fig. 2. If the Burner Tube
does not fit over the Valve Orifice, lighting
the Burner may cause explosion and/or fire.

Figure 2

GAS VALVE ASSEMBLY

ORIFICE

BURNER TUBE

Tools Required for Assembly

#2 Phillips screwdriver
#4 Phillips screwdriver
Adjustable wrench

Long nose pliers
Open-end wrench, 11/16” size
Protective work gloves
Eye protection
Utility knife