Installing the cabinet doors and wire basket, Figure 6a – Kenmore ELITE 141.1668 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Place the Tank Pull-out Tray Kit on the Bottom
Shelf. Extend the Tank Tray outward from its
Bracket so you can align the holes on the Bracket
with the threaded holes on the top of Bottom Shelf.
Tighten securely by using 4 of the 1/4"x1/2" Phillips
Head Screws provided. See Fig. 4. Slide tray back
into Bracket.
6. Before installing the Door Bracket to the
inside of front Cart Side Panels be sure Door
Stops for Magnets on the Door Bracket are
located on the front side. See Fig. 5.
7. Install the Door Bracket to the inside of front
Cart Side Panels. Align the threaded holes on
the Door Bracket with the holes on Cart Side
Panels. Tighten securely by using 4 of the
1/4"x50mm Phillips Head Screws provided.
See Fig. 5.
Figure 4 (LP gas model only)
CART SIDE
Installing The Cabinet Doors and Wire Basket
1. Remove the white protective film from the
stainless steel Door Panel and stainless steel
Door Axle Brackets.
2. Install the Door Axle Bracket-left bottom to
the Left Cart Side Panel. Insert Bracket upright
against Panel inside surface. Align Bracket and
Panel threaded holes. Thread two 3/16" x 9mm
Phillips Head Screws from the Panel front
through Bracket. See Fig.
6
a. Tighten securely.
See Fig.
6
b for correct assembly view.
3. Place the axle on bottom of the Left Door
Panel in the Door Axle Bracket-left bottom.
See Fig.
6
b.
Figure 5
CART SIDE PANEL-LEFT
Figure
6
a
Figure
6
b
CART SIDE
-LEFT BOTTOM
SHELF
11