Kenmore ELITE 141.1668 - Manual (Page 12)

4. Before installing the Door Axle Bracket-left top
to the Left Cart Side Panel, with an assistant,
hold the Door Panel and keep it vertical.
5. Place the axle on top of the Left Door Panel
in the Door Axle Bracket-left top. Install the
Door Axle Bracket-left top to the Left Cart
Side Panel. Align the holes on the Door Axle
Bracket-left top with threaded holes on the top
of Left Cart Side Panel. Tighten securely by
using 2 of the 3/16"x9mm Phillips Head
Screws provided. See Fig.
6 c,
6. Follow steps 1 to 5 of the Installing the Left
Cabinet Door Procedures to install Right
cabinet Doors.
7. Attach the Wire Basket to the Door Trim Plate
-Left as shown in Fig. 6 d. Tighten securely
using 2 of the 1/4"x1/2" Phillips Head screws
provided. Place the Division Wire on the Wire
Bracket.
Figure 6 d
Figure 6c
instaliing The Griii Head
1. Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Fig. 7. If you haven’t already done so, open
the Grill Lid and remove the packed
components. Lock the casters. Even with the
components removed, the next step requires 2
people.
2 .
4.
With an assistants, carefully lift and position
the Grill Head onto the grill cart. Align the 6
holes of the Bowl Side Panel to the threaded
holes on the Cart Side Panel Bracket. Secure
firmly by using 6 of the 1/4"x30mm Phillips
Head Screws provided. BE CAREFUL NOT TO
PINCH FINGERS WHEN LOWERING HEAD
ONTO CART
Open the front Doors of cabinet. Remove fasten­
ing band from Fuel Gauge Display Wire Plug "A"
that is behind the Heat Shield of the Control
Panel.
Place the Wire Plug "A" through the slot in side
of Right Cart Side Panel as shown in Fig. 8 .
-LEFT TOP
Figure 7
Figure 8 (LP gas model only)
CONTROL PANEL
12