Kenmore 122.1613411 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Side Burner Valve Assembly
(a) Remove side burner grate from side burner shelf and
set aside. Remove the two Phillips head screws
attaching side burner (N) to shelf to make room to install
side burner valve. See (Fig.14)
(b) Remove two screws from side burner control valve
face. Insert side burner valve control stem through hole
in side burner control panel. Place side burner control
knob bezel (T) over side burner valve control stem.
Secure bezel to control panel and valve with 2 screws
removed above. (Fig . 15A1).
(c) Insert side burner tube over side burner valve orifice
(Fig. 15B1). Use the two previously removed side burner
screws to reattach side burner to side burner shelf.
(d) Push control knob (U) onto valve control stem, and
tighten use hex wrench. (Fig.16.)
(e) Plug ignition wire into igniter wire hanging from
electrode on underside of burner (Fig. 17).
(f) Replace the side burner grate into the side burner
shelf.
Fig. 16
U
> 1
r
1 /
^'
13