beautypg.com

Electrical connection options, Style 2: direct wire strain relief, And you will be connecting to – Kenmore ELITE OASIS 110.6703 User Manual

Page 9: Electrical connection, D d] vmy

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

Electrical Connection Options

Style 2: Direct wire strain relief

Unscrew the removable conduit connector and any screws

from a %" (1.9 cm) UL listed strain relief (UL marking on strain

relief). Put the threaded section of the strain relief through the
hole below the terminal block opening. Reaching inside the

terminal block opening, screw the removable conduit

connector onto the strain relief threads.

4

B

C

A. Removable conduit connector

B. Hole below terminal block opening
C. Strain relief threads

Put direct wire cable through the strain relief. The strain relief

should have a tight fit with the dryer cabinet and be in a
horizontal position. Tighten strain relief screw against the
direct wire cable.

If your home has:

And you will be

connecting to:

Go to Section:

4-wire receptacle
(NEMA type 14-30R)

(D D]

vmy

A UL listed,

120/240-volt

minimum,

30-amp, dryer

power supply

cord*

4-wire connection;

Power Supply

Cord

4-wire direct

A fused
disconnect or
circuit breaker

box*

4-wire connection:

Direct Wire

3-wire receptacle
(NEMA type 10-30R)

A UL listed,

120/240-volt

minimum,

30-amp, dryer

power supply

cord*

3-wire connection:

Power Supply

Cord

3-wire direct

(8.9 cm)

A fused
disconnect or
circuit breaker

box*

3-wire connection:

Direct Wire

df local codes do not permit the connection of a cabinet-ground

conductor to the neutral wire, go to “Optional 3-wire
connection” section.

4-wire connection: Power supply cord

IMPORTANT:

A 4-wire connection is required for mobile homes

and where local codes do not permit the use of 3-wire
connections.

C

E

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong
D. Neutral prong

E. Spade terminals with upturned ends
F. %" (1.9 cm) UL listed strain relief

G. Ring terminals

4.

Now complete installation following instructions for your type

of electrical connection:

4-wire

(recommended)

3-wire

(if 4-wire is not available)

This manual is related to the following products: