Warning, Complete iristalation – Kenmore HE2 110.9758 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
.
2
.
3.
4.
5.
Check that all parts are now installed. If there is an extra part
go back through the steps to see which step was skipped.
Check that you have all of your tools.
Dispose of/recycle all packaging materials.
Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
Check that the dryer is level. See “Level Dryer.”
^WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground
prong.
Do not
use
an adapter.
Do not
use an
extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Complete Iristalation
7. Remove any protective film or tape remaining on the dryer.
8
.
Read “Dryer Use.”
9. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
10. Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only modifier.
If the dryer will not start, check the following:
■
Dryer is plugged into a grounded 3 prong outlet.
■
Electrical supply is connected.
■
Household fuse is intact and tight, or circuit breaker has
not tripped.
■
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close door. If you do not feel heat, turn off the dryer and
check that the gas supply line shutoff valve is open.
■
If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
6
.
Plug into a grounded 3 prong outlet. Turn on power.
If the gas supply line shutoff valve is open, contact a
qualified technician.
15