Reverse hinge – Kenmore HE2 110.9758 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
Rotate outer door 180°
180
°
Reverse hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, being certain not to scratoh the inner door surface.
Lift up.
2.
Remove the 4 screws that attach to the inner door hinge and
move the hinge to the other side. Reinstali the 4 screws.
3.
4.
5.
Reinstall plug strips on opposite side of the inner door.
Check for fingerprints on the glass. Clean glass if necessary.
Place the inner door assembly inside the outer door
assembly. To fit correctly, the inner door assembly edge fits
completely inside the outer door assembly edge.
6
.
Reassemble the inner and outer door assemblies with the
6 screws.
Use a small flat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the plugs, being certain not to scratch the dryer
surface. Lift up.
Remove the strike
Insert strike on the opposite side.
A. Plug strip (cannot be seen from this angle)
B. Door strike
Reinstall the door
1. Reattach door to dryer front panel with the 4 screws.
A. Dryer front panel
B. Door assembly
2. Check for fingerprints on the glass. Clean glass if necessary.
3.
Close door and check that it latches securely.
14