Kenmore ELITE OASIS Steam 110.6808 - Manual (Page 24)

On
Off
Cycle Signal
О Loud
Soft
Cycle Signal Volume
NOTE: When WRINKLE GUARD® is selected, a tone sounds
every 5 minutes until the clothes are removed, or WRINKLE
GUARD® ends.
You can change Auto and Timed Cycles, Modifiers and Options
anytime before pressing Start.
■ Three short tones sound if an unavailable combination is
selected. The last selection will not be acoepted.
Changing Cycles after pressing Start
1. Press STOP twice.
2. Select the desired cycle and options.
3. Press START. The dryer starts at the beginning of the new
cycle.
NOTE: If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected
Modifier or Option begins.
1. Press STOP once.
2. Select the new Modifier and/or Options.
3. Press START to continue the cycle.
NOTE: If you happen to press STOP twice, the program clears
and your dryer shuts down. Restart the selection process.
Changing the Preset Dryness Level Settings
If all of your loads on all Auto Dry cycles are consistently not as
dry as you would like, you may change the preset Dryness Level
settings to increase the dryness. This change will affect all of your
Auto Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different
installations, environmental conditions or personal preference.
There are 3 drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15% more drying time)
and 3 (much dryer clothes, approximately 30% more drying
time).
1. The Dryness Level settings cannot be changed while the
dryer is running.
2. Press and hold the DRYNESS LEVEL button for 5 seconds.
The dryer will beep, and “CF” will be displayed for 1 second
followed by the current drying setting.
3. To select a new drying setting, press the DRYNESS LEVEL
button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting
will not flash, but the other settings will flash.
4. Press START to save the drying setting.
5. The drying setting you selected will become your new preset
drying setting for all Auto Dry cycles.
The dryer rack was shipped in the dryer drum.
Use the dryer rack for items that you do not want to tumble dry,
such as sweaters.
Use Timed Dry to select the desired time.
NOTE: Do not use Auto Dry Cycles with the dryer rack.
To use the dryer rack:
Do not remove the lint screen.
1. Open dryer door.
2. Slide dryer rack over the bottom of the dryer door opening.
Rest the back wire on the dryer back ledge. Push down on
the frame front to secure over lint screen.
3. Place wet items on top of the dryer rack. Allow space around
items for air to circulate. The dryer rack does not move, but
the drum will rotate. Make sure items do not hang over the
edges or between dryer rack grille.
4. Close the door.
5. Select TIMED DRY and TIME ADJUST MORE TIME or LESS
TIME. Refer to the following table.
6 . Select the desired temperature setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber or plastic must be dried on a clothesline or by
using an air oycle. Refer to the following table.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the dryer rack.
24