Kenmore 141 17690 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Fig.
9. If you haven’t already done so, open
the Grill Lid and remove the packed
components. Lock the casters. Even with the
components removed, the next step requires 2
people.
2. With an assistant, carefully lift and position
the Grill Head onto the grill cart. Align the 6
holes of the Bowl Side Panel to the threaded
holes on the Cart Side Panel Bracket. Secure
firmly by using 6 of the 1/4"x30mm Phillips
Head Screws provided.
BE CAREFUL NOT
TO PINCH FINGERS WHEN LOWERING
HEAD ONTO CART
3. Open the front Doors of cabinet. Remove
fastening band from Fuel Gauge Display Wire
Plug "A" that is behind the Heat Shield of the
Control Panel.
4. Place the Wire Plug "A" through the slot in
side of Right Cart Side Panel as shown in
Fig. 10.
Installing The Grill Head
Figure 9
Figure 10 (LP gas model only)
CONTROL PANEL
13