Kenmore 631 - Manual (Page 9)

Swivel
The attached
hose swivels to
make cleaning
easier in every
direction.
Remove the
hose from the
hose clip by
pulling straight
out.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
Crevice
Tool
Telescoping
Wand
Remove the
telescoping
wand from
its storage
position.
Remove the crevice toot from its storage
position in the wand. Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length. Turn the
locking ring to the LOCK position. Attach the
extension wand onto the open end of the
hose.
Lower
Wand
Suction
Control Slide
Wand _
Locking Ring ~
\Pnloch -------------------------- Upper
Wand
Align the tabs on the extension wand with
the “J” slots in the hose. Push the wand into
the hose and twist to the right to lock.
To achieve maximum reach with
the attachments, add the
Hose-
crevice
tool to the end of
the wand by
inserting and
twisting slightly.
Suction
Control
Slide
Telescoping
Wand'
Crevice
Tool
When using the
dusting brush
or the combina­
tion brush,they
may be
attached direct­
ly to the wand
or placed on
the end of the
crevice tool.
TO OPERATE SUCTION
CONTROL SLIDE
Telescoping Wand
When using
attachments
for cleaning
draperies,
small rugs
with low pile
and other
delicate
items, twist
the suction control slide to the open position.
This lever is located on the telescoping
wand, close to the hose.
This will reduce suction for ease of cleaning.
NOTE: Return suction control slide to the
closed position for normal cleaning.
Suction
Control
Slide
i
A
CAUTION
When using attachments, be careful not to
overextend the stretch hose when reaching.
Trying to reach beyond the hose stretch
capability could cause the deaner to tip over.
Make sure the carpet/bare tioor selector is in
the bare floor posifion. Damage to the floor
surface may occur if the carpet setting is
used.