Warning, Electrical shock hazard, Handle assembly – Kenmore 631 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Electrical Shock Hazard
Do not plug into the electrical supply
until the assembly is complete. Failure
to do so could result in electrical shock
or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received ail the components of
your new Kenmore vacuum.
Remove the tape located below the dust
cover/filter cover on the motor case.
Attach
stretch hose
end to noz
zle as
shown.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra
tion below.
Slide the handle into the opening at the top
of the vacuum.
-Handle
Insert the screw so it passes through the
handle into the vacuum.
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly.