Kenmore 631 - Manual (Page 17)

TO CLEAN AGITATOR
NOTE: in order to keep cleaning efficiency
high and to prevent damage to your vacu­
um, the agitator must be cieaned every time
the belt is changed.
The agitator must be cleaned according to
the following schedule:
Vacuum Use
HEAVY
(used daily)
MODERATE
(used 2-3 times/week)
LIGHT
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
Remove ant dirt or derbris in the belt path
area or in the agitator area.
Exploded View - Agitator
Assembly
Carefully remove the brush end caps and
remove any string or debris located on the
agitator assembly, end caps, washers or
agitator shaft.
End
End Cap
NOTE: Replace
the end caps. See
the exploded view
for correct assem­
bly.
TO REPLACE BELT
Make sure that the carpet/bare floor selec­
tor is in the carpet position.
Loop the new belt on the motor shaft.
Motor
Shaft
Belt Wew
Pulley
Carpet/Bare Floor
Selector Shaft
BELT ROUTING
Correct Routinq of Belt
(SelectorIn CarpetPosition)
g o T t
fPositic
Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Belt on SelectorShaft)
, Carpe t/Bare
jrD'Q' 'FloorPedal
^ Motor
Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector in Bare Floor Position)
Carpet/Bare
' n Floor Pedal
Carpet/Bare Floor
Selector Shaft
17