Kenmore 631 - Manual (Page 15)

Check motor safety filter frequently and
change when dirty.
A
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock.
Motor
Safety
Filter
Remove the dust bag as outlined in the
DUST BAG CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
1. This white & grey
filter must be
replaced when dirty.
It should be
replaced regularly
depending on use
conditions. The fil­
ter CANNOT be
washed as it will
lose its dust trap­
ping ability.
NOTE: See PARTS AND FEATURES for
motor safety filter number.
2. If the filter,
located in the bot­
tom of the bag
cavity, is dirty,
remove it by
pulling forward out
from under the
ribs.
3. Replace the
filter,
white side
up, by sliding it
back into place
under the ribs in
the bag cavity.
Motor
Safety
Filter
Replace the bag as outlined in the DUST
BAG CHANGING section.
A
WARNING
Do not operate without exhaust
fitter.
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be
replaced when dirty. It should be
replaced regularly depending on use
conditions. The filter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
the exhaust filter number.
Slide the
exhaust filter
cover release
down. Pull out
on exhaust fil­
ter cover to
remove from
bag cover.
Exhaust Filter
Cover Release
Exhaust
Filter
Cover
Exhaust
Filter
Remove the
exhaust filter car­
tridge from the
bag cover.
Replace the exhaust filter
cartridge, carefully posi­
tioning it so that it fits into
the bag cover.
The grey
edge of the filter should
be facing away from the
operator.
Push only on
filter cartridge frame, not
on filter itself.
Bag
Cover —I
Exhaust
Filter
3
Replace the
exhaust filter
cover and
secure the
latch by push­
ing it upward.
15