beautypg.com

Side venting kit installation list of parts, Tools needed, Option 2 : bottom venting – Kenmore ELITE 796.8051 User Manual

Page 31: Side venting kit installation, Awarning, Optional accessories

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPTIONAL ACCESSORIES

SIDE VENTING KIT INSTALLATION

List of Parts

The following parts are included with the pedestal.

• Duct Outlet (A) (blower - elbow)
• Duct Elbow
• Duct Outlet (B) (elbow - outlet)
• Cover Plate
• Installation Instruction
• Screw

Tools Needed

The following tools are needed for installation.

• 1 #2 Phillips screwdriver
• 1 adjusting wrench for leveling feet (included)

AWARNING:

• Use a heavy metal vent.
• Do not use plastic or thin foil duct.
• Clean old ducts before installing this dryer.
• Wear gloves during installation.
• Failure to follow these instructions can result in death

or fire.

Your new dryer is shipped to vent to the rear. It can
also be configured to vent to the bottom or side

(right-side venting is not available on gas models).

Option 1 : side venting

(Gas dryers can only be vented to the left side.)

Rear
Exhaust Duct

Retaining
Screw

o Remove the rear exhaust duct retaining screw. Pull

out the exhaust duct.

r

Adapter

Duct

A

Press the tabs on the knockout and carefully
remove the knockout for the desired vent opening
(right-side venting is not available on gas models).
Press the adapter duct onto the blower housing

and secure to the base of the dryer as shown.

Eibow

Assemble the 4 in. (10 cm) elbow to the remaining
4 in.(10 cm) duct section, and secure all joints with
duct tape. Be sure that the male end of the elbow
faces AWAY from the dryer. Insert the elbow/duct
assembly through the side opening and press it
onto the adapter duct. Secure in place with duct
tape. Be sure that the male end of the duct
protrudes 11/2 ¡|-|

(3

8 cm) to connect the remaining

ductwork. Attach cover plate to the back of the
dryer with included screw.

y

Option 2 : Bottom venting

Rear
Exhaust Duct

Retaining
Screw

o Remove the rear exhaust duct retaining screw. Pull

out the exhaust duct.

(/}

O

z

IIJ

Adapter
Duct

Bracket ■

Knockout

Press the adapter duct onto the blower housing

and secure to the base of the dryer as shown.

Eibow

Insert the 4 in. (10 cm) elbow through the rear

opening and press it onto the adapter duct. Be sure
that the male end of the elbow faces down through

hole in the bottom of the dryer. Secure in place

with duct tape. Attach the cover plate to the back of
the dryer with included screw.

31

This manual is related to the following products: