beautypg.com

Warning – Kenmore ELITE 796.8051 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION INSTRUCTIONS

VENTING THE DRYER (cont.)

Routing and Connecting Ductwork

Follow the guidelines below to maximize drying

performance and reduce lint buildup and condensation
in the ductwork.

NOTE: Ductwork and fittings are NOT included and must
be purchased separately.

• Use 4 in. (102mm) diameter rigid or semi rigid metal

ductwork.

• The exhaust duct run should be as short as possible.

• Use as few elbow joints as possible.

• The male end of each section of exhaust duct must

point away from the dryer.

• Use duct tape on all duct joints.

• Insulate ductwork that runs through unheated areas

in order to reduce condensation and lint buildup on duct
surfaces.

• The Total length of flexible metal duct shall not exceed 8

ft.(2.4m)

• In Canada, only those foil-type flexible ducts, if any,

specifically identified for use with the appliance by the
manufacturer shall be used. In the United States, only

those foil-type flexible ducts, if any, specifically identified
for use with the appliance by the manufacturer and that
comply with the Outline for Clothes Dryer Transition Duct,

Subject 2158A, shall be used.

WARNING:

Failure to follow these

guidelines will result in poor performance, product

failure, and/or result in fire or death.

IMPORTANT: Fai lure to exhaust the dryer per the
guidelines included within these instructions may result
in unsatisfactory dryer performance. All venting and

ductwork beyond the exterior of the dryer is the

responsibility of the consumer. Product failure as

a result of improper venting is not covered by the

manufacturer’s warranty.

Correct Venting

(/}

o

z

UJ

Incorrect Venting

Connecting the Dryer Vent

O

Verify all ducts and elbows are clean and free from any

blockages.

Measure duct length. DO NOT exceed the maximum
length listed in the chart on page 14.

O Connect dryer exhaust to existing ductwork.

• Use duct tape or clamps only.
• DO NOT use screws to secure ductwork.
• Use rigid or semi rigid metal duct.
• DO NOT use plastic or thin metal foil tubing for

ductwork.

• The male end of each elbow must always point in the

direction of the airflow.

Al^

15

This manual is related to the following products: