Control panel features, Warning – Kenmore ELITE 796.8051 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE
WARNING:
To reduce the risk of fire, eiectric shock, or injury to persons, read this entire
manual, including the Important Safety Instructions, before operating this dryer.
CONTROL PANEL FEATURES
m
z
o
r
(A
X
o POWER (On/Off) BUTTON
Press to turn the dryer ON. Press again to turn
the dryer OFF.
NOTE: Pressing the Power button during a cycle will can
cel that cycle and any load settings will lost.
© CYCLE SELECTOR KNOB
The OYOLE SELEOTOR KNOB is used to select the
desired dry cycle by rotating the knob in either direc
tion until the desired cycle LED is illuminated. Once
the desired cycle has been selected, the standard
presets for that cycle will be shown in the display.
These settiras can be adjusted using the Oycle
Modifier or (Option buttons anytime before starting the
cycle. (See the Oycle Guide on page 20 for allowable
settings. To protect your fabrics, not all settings are
allowed in all cycles.)
0 START/PAUSE BUTTON
Press the START/PAUSE button to begin the cycle.
The display will change, and the dryer will display the
estimated (SENSOR TOI^Y) or set time (MANUAL
DRY) remaining and start tumbling. To pause the
CTcle at any time, open the dryer door or press
PAUSE. To resume the cycle where it was stopped,
press START/PAUSE again.
NOTE: If the dryer has been stopped for more than 4
minutes, the dryer will turn off automatically.
0
OPTION BUTTONS
The option buttons allow you to select additional
cycle options. The controls can be locked or
unlocked by pressing and holding the Control Lock
button for 5 seconds.
MORE TIME and LESS TIME options are not
available with sensor dry cycles.
For detailed information about the individual options,
please see the following pages.
0 CYCLE MODIFIER BUTTONS
Use these buttons to adjust the desired cycle options
for the selected cycle. The lights above the buttons
show the current selection. See page 23 for a
complete description (NOTE: Some settings are
not allowed on some cycles.).
0 TIME AND STATUS DISPLAY
The display shows the estimated time remaining and
the cycle status. The display also monitors the vent
and lint filter status. See page 22 for a complete
description.
MY CYCLE
If you have a special combination of settings
that you use frequently, you can save these
settings as a MY CYCLE.
18