Installation clearances, Washer dimensions – Kenmore 110.4646 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation clearances
■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90° and
it is not reversible.
■ Additional clearances might be required for wall, door, and
floor moldings.
■ Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
Washer Dimensions
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
(7,6 era)
48 iri.
(310 cm
|r 29V4" -H 4"
(2.5 era) (go cm) (10.2 cm)
(7,6 era)
A. Side view - closet or confined area
B. Closet door with vents
* Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
Recommended installation spacing for custom
undercounter installation
A. Recessed area
B. Side view - closet or confined area