Installing the range, Storage drawer removal, Final check of the anti-tip bracket – GE EER2000 User Manual
Page 9: Level the range, Replacing the oven door, Installation instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Range
Installation Instructions
Storage Drawer Removal
D1
D2
D3
Pull the drawer
out until it stops
Lift the front of
the drawer until
the stops clear
the guide.
Remove the
drawer.
Final Check of the Anti-Tip Bracket
D4
When installation is
complete and the
range is in place,
inspect to be sure the
rear leveling leg is fully
inserted into the slot of
the Anti-Tip Bracket.
Level the Range
The range must be level for proper cooking and
baking.
D5
D6
D7
D8
Install the oven racks.(See Owner’s
Manual for instructions.)
Put a spirit level or a glass
measuring cup partially
filled with water on one of
the oven racks.
Remove the
storage drawer.
The front leveling
legs can be
accessed from the
bottom and the
rear legs from the
top.
Use an adjustable wrench to adjust all four
leg levelers until the range is level.
CAUTION: The oven door is heavy.
You may need help lifting the door
high enough to slide it into the
hinges slots. Do not lift the door by
the handle.
Replacing the Oven Door
D9
D10
D11
D12
D13
Pick the Oven Door up
by placing both hands on
each side. The door is
heavy so you may need
help. Do not lift the door
by the handle.
Place the notch of the
hinge arm into the bot
tom edge of the hinge
slot.
Open the oven door
as far as it will open.
Push the hinge locks
up against the front
frame of the oven
cavity, to the locked
position.
Close the oven door.
Bottom Edge Hinge Arm
Of Slot,
‘
Hinge Notch
Hinge in
Locked Position
/
Notch of
Hinge Securely
Fitted into Bottom
of Hinge Slot
WM
Continued on following page