B electrical connections, New construction and four wire cord connection kit, Installation instructions – GE EER2000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions
B Electrical Connections
cont.
B3
B4
B5
B6
B7
NEW CONSTRUCTION AND FOUR
WIRE CORD CONNECTION KIT
Complete 4 wire
cord kit. Beiow are
step by step
instructions on
how to install the
kit.
Remove the screws on
the terminal block with
a 1/4” nut driver or
Phillips screwdriver.
Knockout In center
of connection plate
may be taken out
Remove the ground
screw using a 5/16”
nut driver, then
remove and discard
the ground strap. Do
not discard the
ground screw, you
will need it later.
Install the four-wire
cord and strain
relief through the
hole in the
connection plate.
Ground
4 wire
B8
B9
BIO
B11
Attach the green lead
below the junction
block with the ground
screw that was
removed earlier.
Connect the red
and black leads to
the outside
terminals and the
white lead to the
center terminal.
Push the cord upward (to relieve strain),
while tightening the strain relief clamp.
Re-install the wire cover with the 5
screws removed earlier. Make sure the
wires do not become pinched between
the wire cover and mainback.
Wire
Cover
Three-wire connection continued on following page