GE EER2000 - Manual (Page 3)

Pre- Installation Checklist
Installation Instructions
0 Preparing the Range
Remove packaging materials. Any
packaging materials must be removed
during installation. This will include
adhesive tape, wire ties, cardboard and
protective plastic. Failure to remove
these materials could result in damage to
the appliance once the appliance has
been turned on and surfaces have
heated.
Open oven door and remove literature
pack, broiler pan and grid, and oven racks.
Close the oven door to
the broil stop position.
O'
sr
Place hands on both
sides of the door. As you
close the door, lift up and
away from the range.
o'
Remove Installation Instructions
from literature pack and read it
carefully before you begin. Be
sure to place ail literature, Use
and Care, Installation
Instruction, etc. in a safe place
for future reference.
Cpen the oven door as
far as it will go.
S' Lift door up until the
hinges clear the slots.
\i
V.-'-
Hinge
Cleats
Slot
DO NOT LIFT THE DOOR BY THE HANDLE!
NOTE: The oven door is very heavy. Be sure you
have a firm grip before lifting the oven door off the
hinges. Use caution once the door is removed. Do
not lay the door on its handle. This could cause
dents or scratches.
Push the hinge locks
down toward the door
frame, to the unlocked
position. This may
require a flat blade
screwdriver.