6 modem settings – Cradlepoint IBR650 User Manual

Page 83

CRADLEPOINT

IBR650 | USER MANUAL Firmware ver. 3.3.0

HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/

FOR MORE HELP AND RESOURCES

PAGE 81

7.6 Modem Settings

This section allows you to change the
settings for your embedded modem.

7.6.1

Update/Activate a Modem

The embedded modem can be
activated (or reactivated/upgraded).
Select the checkbox next to the
CradlePoint

device and click ―Update /

Activate‖.



Modem Activation / Update: Activate, Reactivate, or Upgrade Configuration. Click Activate to start the process.

If the modem is connected when you start an operation
the router will automatically disconnect it. The router may
start another device as a failover measure. When the
operation is done the modem will go back to an idle state,
at which point the router may restart it depending on
failover and failback settings.

NOTE: Only one operation is supported at a time. If you try to start
the same operation on the same modem twice the UI will not report
failure and the request will finish normally when the original request is
done. However if you try to start a different operation or use a
different modem, this second request will fail without interfering with
the pending operation.

Process Timeout: If the process fails an error message
will display.

Activation has a 3-minute timeout.