Whirlpool Thin Twin User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4. Preform the flex pipe to the left or right. Pull

the flexpipe through the knockout opening

until the clip “snaps” into place.

(Fig. 9)

NOTE: The flex pipe may also be used to

exhaust down or straight out the

back. In these cases, the clip is
not needed.

5. Maintain the position of the dip with one hand

and secure the screw with the other hand. Make

sure the screw is snug against the flex pipe,

but do not break through.

(Fig. 10}

SCREWDRIVER

Fig. 9

6. Tape all of the connections with duct tape, then proceed with the installation.

NOTE: When changing vent directions, use plugs to cover the panel exhaust holes.

692790-White Plug

692791 - Almond Plug