Carl Goldberg GBGA1089 - Manual (Page 3)

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 RADIO GUIDANCE SYSTEM (6 CHANNEL
MINIMUM REQUIRED WITH 8 SERVOS)
2 12” AILERON SERVO EXTENSION WIRES
2 24” ELEVATOR SERVO EXTENSION
WIRES
3 Y-HARNESS (1 with reversing)
1 ENGINE .61-.108 2-STROKE, .91- 1.20 4-
STROKE AND MUFFLER
1 CA ACCELERATOR
1 2 OZ. BOTTLE CA MEDIUM GLUE
1 1/2 OZ. BOTTLE CA THIN GLUE
1 20 MINUET EPOXY
1 1/4” FOAM RUBBER
1 20” String
NOTE: The Stinson ARF covering matches White
(#870), Deep Blue (#873) and True Red
(#877) Oracover.
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X70")
ELECTRIC DRILL
1/16”, 3/32”,1/8", 3/16”, 5/32”, 1/4”, 5/64”
7/32” DRILL BITS
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
MOTO TOOL
24” RULER
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
ADJUSTABLE WRENCH
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
ELECTRICAL TAPE
PIECE OF MEDIUM SANDPAPER
5 FT. LENGTH OF STRING
4-40 DRILL AND TAP SET
Caution:
Before starting, carefully go over all high
stress areas with an epoxy or a wood glue to
confirm all areas are well glued.