Carl Goldberg GBGA1082 - Manual (Page 6)

6
9. Using rubbing alcohol, clean the bottom of the
servo where the double sided tape will be
applied.
Making sure that the both the wing and the
servo are dust free, apply a piece of double
sided tape to the servo.
remove the other side of the tape and mount
the servo in the wing.
To help secure the servo more, glue the servo
in place using a hot glue gun.
10. Thread the nylon clevis onto the threaded
rod..
Attach the clevis to the wooden control horn.
Mark where the pushrod wire meets the servo
arm and make a 90 degree bend.
put the wire through the servo arm and attach
the nylon swivel keeper.
Cut off any excess wire.
“V” TAIL INSTALLATION
1. Collect the following parts:
(1) “V” Tail
(1) Fiberglass Fuselage
(1) 120 Grit Sand Paper
1. Using a soft lead pencil, mark the location
where the stab meets the fuselage.
2. Remove the stab from the fuse and, working
1/16" inside the drawn lines, carefully remove
the covering from the bottom of the stab. BE
CAREFUL TO AVOID CUTTING THE WOOD.
Sand the fuselage using 120grit sandpaper, at
the location where the “V” tail will be glued.
(Sand only enough to rough the surface for
the glue to stick).
Fuselage