Carl Goldberg GBGA1082 - Manual (Page 4)

4
Wing
Installing Ailerons
1. Collect the following parts:
(2) Wing ( Left & Right)
(2) Ailerons ( Left & Right)
(8) Mini CA hinges
(2) Wood control horns
3. Locate the pre-cut aileron hinge slots in both
sides of the wing. Using a hobby knife (#11
blade), slide the blade into each slot to make
sure it is cleanly cut.
Repeat this process with the ailerons, making
sure all hinge slots are clean.
4. Insert the CA hinges half way into the wing
and the ailerons. (Use a pin inserted into the
middle of the hinge to help keep the hinge in
the middle.)
Make sure that the aileron is against the wing
and evenly spaced at both ends of the wing
cut out.
Using thin CA glue, place one drop on all four
hinges top and bottom.
Repeat these steps for the other aileron.
1. Locate the pre-cut control horn slots in both
ailerons.
Using a hobby knife (#11 blade), slide the
blade into each slot to make sure the covering
is cleanly cut. The slot is 2-5/8” from the end
of the aileron
Making sure that the aileron is upside down,
insert the wood control horn in the slot.
2. Keep the control horn perpendicular to you
table top and the end flush with the top of the
aileron.
Thin CA glue the control horn into the aileron.
Repeat this process with the other aileron.
Aileron Servo Installation
1. Collect the following parts:
(2) Mini servos
(2) 6” servo extensions
(1) Electrical Tape
(1) Hex Nut
(1) 45cm length of string
(1) Double sided servo tape
(2) Nylon Clevises
(2) Threaded pushrods
(2) Nylon Swivel Keepers
1. Locate the servo hole in the bottom of the
wing
Using a hobby knife (#11 blade), remove the
covering over the hole.
2. Tie the hex nut to one end of the 45cm string.
Tape the other end of the string to the bottom
of the wing next to the servo hole.
Insert the hex nut into the servo hole and let it
fall down into the wing rib hole through the
wing till it exits the root wing rib hole.