Carl Goldberg GBGA1046 - Manual (Page 12)

ELEVATOR SERVOS
1. Collect the following items
(2) Servos
(2) 2-56 x 32” pushrods
(2) 2-56 clevis
(2) silicone clevis keepers
(2) nylon swing in keepers
2. Locate the hole in the fuselage side and install
the 2-56 pushrod into the pushrod tube
already installed in the fuselage.
3. Slide the silicone clevis keeper on the clevis.
Screw the clevis on the pushrod till the threads
extend past the end 1/16”.
Attach the clevis to the elevator control horn.
4. Install the two servos in the servo tray in the
rear most holes.
5. Install your control horns. You will need heavy
duty long horns (1”) to get full 3-D throw.
Make sure the elevator is centered and the
servo is centered.
Mark the location of the bend on the wire
where it crosses the control horn.
12