Cadillac 2011 SRX - Manual (Page 408)

Black plate (70,1) Cadillac SRX Owner Manual - 2011
10-70 Vehicle Care
There are two minutes to match
the first tire/wheel position, and
five minutes overall to match all
four tire/wheel positions. If it takes
longer, the matching process stops
and must be restarted.
The TPMS sensor matching
process is:
1. Set the parking brake.
2. Place the vehicle power mode
in ON/RUN/START. See Ignition
Positions on page 9‑18.
3. Select the vehicle information
menu using the menu button.
4. Select the tire pressure screen
using the up/down thumbwheel.
5. Press and hold SET to begin the
sensor matching process.
6. Press SET to confirm selection.
The horn sounds twice to signal
the receiver is in relearn mode
and TIRE LEARNING ACTIVE
message displays on the DIC
screen.
7. Start with the driver side
front tire.
8. Place the relearn tool against
the tire sidewall, near the valve
stem. Then press the button
to activate the TPMS sensor.
A horn chirp confirms that the
sensor identification code has
been matched to this tire and
wheel position.
9. Proceed to the passenger
side front tire, and repeat the
procedure in Step 5.
10. Proceed to the passenger
side rear tire, and repeat the
procedure in Step 5.
11. Proceed to the driver side rear
tire, and repeat the procedure
in Step 5. The horn sounds two
times to indicate the sensor
identification code has been
matched to the driver side rear
tire, and the TPMS sensor
matching process is no longer
active. The TIRE LEARNING
ACTIVE message on the DIC
display screen goes off.
12. Press STOP to turn the
ignition off.
13. Set all four tires to the
recommended air pressure
level as indicated on the Tire
and Loading Information label.