Behlen 76078477 - Manual (Page 8)

F-19712-2 Rev. 8-26-03 6-1-01
Step 4
Once the pen is set in place, it is now time to assemble the interior cees and zee. Two people
are needed for this process for safety purposes.
4a. To begin, start on the low side. Lift the 8-inch cee (2) up to the bottom clips and rest on
the side channel clips. Be sure that the 8-inch cee (2) is positioned as shown on the
illustration. The open face of the 8-inch cees has to face into the pen. Fasten at each
end with two-1/2” x 1” hex head bolts (7a) and two-1/2” nuts (7c).
4b. Follow the same instructions for the 8-inch zee (3) and the high side 8-inch cee (2). Make
note of the position to ensure proper assembly.
4c. Insert the rubber strip (7h) around the entire end of the end cee on the low side. See
Detail B. Cut any excess rubber strip off. Repeat this process for the other side. This will
take away any sharp edge that could endanger your animal.
Detail B
Partial view
shown
for clarity
purposes
Trim with rubber
strip (7h). Repeat
on other end cee.
7c (2 req’d. at each
structural to clip connection)
2
3
1 2
7c (2 req’d. at each
structural to clip connection)