Behlen 76078477 - Manual (Page 5)

F-19709 6-1-01
NOTE: Each shelter post (tall and short) has
an extra set of key holes located toward the
top of the post. Use these holes only if you
want a short shelter height.
The assembly instructions are showing how
to set up a shelter using the bottom set of key
holes for the tall shelter height option.
12’ XT Corral Panel
OR
12’ Horse Stall Panel
7d
(3 req’d.
for
each
shelter
post)
7c (3 req’d. for
each shelter post)
NOTE:
When fastening, keep in mind,
which side of the corral panel will
be the inside of the pen. Place the
bolt heads on the inside of the pen
to ensure a smooth surface for the
safety of the animal.
NOTE:
If you are planning on erecting an add-on section onto the shelter, read through both the
instructions. This will eliminate rework.
If sheeting will be installed, do not install it until all sections of the shelter are erected.
Step 1
1a. For assembling ease, lay the panel down. Slide the tall shelter post (5) and the short
shelter post (4) onto the vertical 2” tube. If assembling the shelter on a 12’ XT Corral
Panel, be sure the cap rests in the three slots provided on the shelter posts.
1b. Fasten each shelter post (4 & 5) with three-½” x 3” plated carriage bolts (7d) and
three-½” nuts (7c).
7d
5
7c
4