Behlen 38100229 User Manual
Behlen For pets
ASSEMBLY INSTRUCTIONS
Magnum Dog Kennel
Hardware Kit 38900057
38900059
38900099
Typical Dog Kennel Setup
CUSTOMER SERVICE CENTER
F-19029-5
TECHNICAL INFORMATION 70095
11-4-03
PO Box 569
Ph: 1-800-447-2751
Columbus, NE 68602-0569
Fax: (402) 563-7447
Thank you for purchasing this product
For questions about this product, please contact the Customer Service Center listed below.
Assembled
Latch
The Dog kennel latch system has two
main components, the Latch #2208063
and the Catch Plate #38600729. The
latch will attach to the outer tube in the
doorway of the front panel, this tube has
two holes in it. Loosely attach with two
carriage bolts and lock nuts. The Catch
Plate is attached to the door using the
one hole in it. Loosely attach this with
one carriage bolt and lock nut. Close the
door and adjust both latch components
for smooth latching. Tighten all bolts on
the latch assembly. (See illustrations)
To attach panels, one side of the clamp will have
to be inserted between the wire and the vertical
tube before the other side of the clamp can be
attached. A clamp should be attached (as
shown at right) one at the top and one at the
bottom of each panel.