Avlink HDMI-EN - Manual (Page 4)

Installation
1. Turn off the DVD and HDTV.
2. Connect the HDMI extension cable between the DVD and the “HDMI In” port of HDMI-LN.
3. Connect the HDMI extension cable between the HDTV and the “HDMI Out” port of HDMI-RN.
4. Connect the CAT.5 cables between the HDMI-LN “CAT.5” port and the HDMI-RN “CAT.5” port
of extender.
5. Connect the power cord and turn on the extender.
6. Turn on the DVD and HDTV.
IR-BOX Directions:
Put it into the HDMI-RN “EXT. IR” port and place the IR-BOX, so that you can point to it easily
with your IR remote controller.
IR BLASTER Directions:
Plug IR blaster plug into HDMI-LN “IRBLASTER” port, It sits in front of the DVD receiver’s IR
sensor, which is located on the front-panel.
Additional Options
Select any additional options you may require.
1. IR-BOX
GND
+V
Sig
2. IR BLASTER
NC
P+
N-