Antari F-3 - Manual (Page 9)

9
There is an air pump sensor inside F-3. Keep pressing MANUAL button and power on
F-3 machine, until LCD screen indicates “AirPump Sensor On”. At this point, use Up or
Down buttons to switch this sensor on or off. Please note the sensor is a very important
protection device. Under normal operation mode, please assure the sensor is activated
on. After above setting is completed, press VOLUME button can memorize the final
setting and leave setting mode.
6. Power off the machine
Keeping the button MANUAL pressed for 3 seconds when the display indicates »Ready
to Fazer« can power off the machine. If the machine is switched off this way, the display
will start to count down for 3 minutes. Afterwards, the machine will discontinue to warm
up and the fan operation and the air pump will stop. The diplay indicates » Power Off«.
Note:
A、
During the 3-minute count down, pressing the button VOLUME exits this mode and
makes heater and fan work again. Once the air pump has stopped working, it cannot
be reactivated. If the air pump is still working, it will stop once the auto cleaning
process is completed.
B、
When the machine is in Power Off mode, pressing the button VOLUME can
reactivate the unit and make heater and fan work. However, the air pump will not
resume working.
C、
If the machine is controlled by DMX, disconnecting the DMX connection causes the
unit to enter the Power Off mode and it will start to count down 3 minutes to
shutdown.
DMX Connector Pin Assignment
The machine provide 3 or 5 pin XLR connector for DMX connection. Diagram below indicate
pin assignment information