Antari F-3 User Manual
Page 5
5
Assembly
1. Open the carton and carefully remove all packing materials.
2. Place the fog machine on a flat surface and make sure that no foreign objects or dust
can enter the air vents at the bottom of the machine.
Operation
1. Open the flight case at the front of the machine.
2. Remove the silver cap from the fluid tank and pour in Antari FLG Heavy Fog Fluid.
Replace the tank cap. Verifiy that the liquid pipe is porperly connected and not loose
due to transportation.
Attention! Only use Antari FLG Heavy Fog Liquid. Any other types of fog fluid
may cause unsatisfactory results, pose a health hazard to humans and
animals, cause environmental pollution, or corrosion of inner parts of the
machine. Damage caused by the use of other fluids is not subject to warranty.
3. The machine is equipped with a lockable power input connector. Plug in the power
cord and turn it to the right until it locks. Plug the power cord into a grounded electrical
outlet that matches the rated voltage of the machine.
4. The design of this machine does not include an additional power switch. When
connecting the machine to a power outlet it is powered on. The machine starts with the
warm-up process and the display indicates »Warming Up«.
1
2
2
!