Antari F-3 - Manual (Page 8)

8
Press the button FUNCTION until the display indicates »Fan Speed 20%«. Use the
buttons UP and DOWN to adjust the fan speed.
Please note that in standby mode, the machine resets the fan speed to 20 % in order to
recduce the noise production to a minimum.
Setting the DMX512 address
Press the button FUNCTION until the display indicates »DMX 512«. Use the buttons UP
and DOWN to adjust the DMX512 start address. Please refer to chapter DMX512 settings
for more information on DMX operation.
2. Timer operation
In the timer mode, the fog machine will automatically emit fog. The time intervals,
duration and fog volume depend on the corresponding menu settings. Press the button
TIMER, to activate the timer mode. The display indicates the set time interval. The unit
counts down to 0 seconds and emits fog. To deactivate the timer mode, press the button
MANUAL. The unit is able to continuously produce fog without the need to reheat.
3. Continuous operation
Press the button VOLUME, to activate continuous fog output. The display indicates
»Volume« followed by the value that was set in menu item »Volume Output«. To stop
the fog output, press the button MANUAL. The unit is able to continuously produce fog
without the need to reheat.
4. Quick Start mode
If the “Quick Start” mode is activated, the F-3 will call the operating mode of the previous
operation when it is turned on. For instance, if timer mode was selected last, the machine
will be directly in timer mode after the warm-up process is completed.
Press the button FUNCTION until the display indicates »Quick Start On«. Use the
buttons UP and DOWN to deactivate the quick start mode (indication »Quick Start Off«)
and to reactivate it (indication »Quick Start On«)
5. Switching the air pump sensor on and off