Operating instructions, Warning – Vermont Casting DVR28IN User Manual

Page 19

20012301

Vermont Castings DVR28 Direct Vent Gas Fireplace

two or three times with a non-ammonia household
cleaner and warm water (gas ﬁreplace glass cleaner
is recommended). After the initial cleaning process the
glass should be cleaned two or three times during each
operating season depending on the environment in the
house.

Clean the glass after the ﬁrst two weeks of
operation.
Never clean the glass while it is still hot.
Never use abrasive cleaners.
Never strike or slam the glass.

Glass Information

Operating Instructions

Window Frame Assembly Removal

1. Turn the ﬁreplace OFF (including the pilot).
2. If the unit has been operating, allow time for the

components to cool.

3. Remove two (2) bolts on bottom side of unit holding

front trim face on. (Fig. 32)

4. Remove front trim face by tilting bottom out and lift-

ing face off unit. (Fig. 32)

5. Remove two (2) bolts securing bottom door frame to

unit. (Fig. 31)

6. Tilt window frame assembly out slightly at the bot-

tom, lift the frame up and away from the ﬁreplace.
(Fig. 31)

7. To replace window frame assembly reverse proce-

dure.

��
��
��

Window Frame
Assembly

Fireplace
Front

Glass
Panel

Fig. 31 Window frame assembly removal.

FP1758

Glass Cleaning

It is necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight ﬁlm on the glass.
It is therefore recommended the glass be cleaned

Removal and Re-ﬁtting the Curve Face

The Curve face is ﬁtted to the ﬁreplace by hooking the
top edge of the face over the mounting brackets as
shown in Figure 32. Secure with two (2) screws on the
bottom face of the trim. (Fig. 32)

��
��
��

Curve Face

Bottom Bracket

Control Cover Plate

KT779

Fig. 32 Hang Curve Face in place.

Top Mounting

Brackets

��

�

��

WARNING

Never attempt to operate this direct vent ﬁreplace
if the front glass panel is missing, open, cracked
or broken, as carbon monoxide poisoning could
result.
Always use a licensed, qualiﬁed service technician
to install replacement glass.
Always install genuine CFM Corporation
replacement glass in this ﬁreplace. Authorized
replacement glass (complete with gasket and
window frame) is available from your CFM
Corporation dealer.
The installation of non-authorized replacement
glass will also void all product warranties.