Lights – Acura 2000 Integra Hatchback - Owner's Manual User Manual
Page 213
Lights
Replacing Rear Turn Signal and
Side Marker Light Bulbs
1. Open the hatch and remove the
light assembly cover by pulling the
edge.
2. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.
3. If the turn signal light bulb is
burned out, remove it by pushing
it in and turning counterclockwise.
If the side marker light bulb is
burned out, remove it by pulling it
straight out of its socket.
4. Install the new bulb in the reverse
order of removal.
5. Push the socket into the light
assembly and turn it clockwise
until it locks.
6. Test the lights to make sure the
new bulb is working.
7. Install the light assembly cover.
Make sure it locks in place.
Replacing Tail/Stoplight and
Back-up Light Bulbs
1. Open the hatch. Remove the
tether hardware cover with a small
flat-tip screwdriver and tether
anchor plate with a wrench by
turning the bolt counterclockwise.
When reinstalling tether hardware,
see
Protecting Children on page
.
On Type-R model
You cannot replace these bulbs
yourself, contact your Acura dealer.
Maintenance
Main Menu
Table of Contents