Acura 2002 RL - Owner's Manual - Manual (Page 282)

Moisture trapped in body cavities.
Dirt and road salt that collects in
hollows on the underside of the
vehicle stays damp, promoting
corrosion in that area.
Repair chips and scratches in the
paint as soon as you discover them.
Inspect and clean out the drain
holes in the bottom of the doors
and body.
Check the floor coverings for
dampness. Carpeting and floor
mats may remain damp for a long
time, especially in winter. This
dampness can eventually cause
the floor panels to corrode.
Two factors normally contribute to
causing corrosion in your car: Many corrosion-preventive measures
are built into your Acura. You can
help keep your car from corroding
by performing some simple periodic
maintenance: Use a high-pressure spray to clean
the underside of your car. This is
especially important in areas that
use road salt in winter. It is also a
good idea in humid climates and
areas subject to salt air. Be careful
of the ABS wheel sensors and
wiring at each wheel.
Have the corrosion-preventive
coatings on the underside of your
car inspected and repaired
periodically. Removal of paint and protective
coatings from the exterior and
underside of the car.
1.
2.
Corrosion Protection
Appearance Care 279
01/09/28 20:11:02 31SZ3660_282
Main Menu Table of Contents