Acura 2002 RL - Owner's Manual - Manual (Page 132)

You can use any of three methods to
find radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the TUNE knob to the right to
tune to a higher frequency, or to the
left to tune to a lower frequency.
Turn the knob right or left until the
display reaches the desired
frequency.
You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency
on the AM band, and two
frequencies on the FM band.
The SEEK function
searches the band for a station with
a strong signal. To activate it, push ei-
ther side of the SEEK/SKIP buttons
(
or ). Push the button to
scan up from the current frequency,
and the
button to scan down. It
stops when it finds a station with a
strong signal.
The band and frequency that the ra-
dio was last tuned to is displayed. To
change bands, press the AM/FM but-
ton. On the FM band, ST will be dis-
played if the station is broadcasting
in stereo. ST will flash if you are driv-
ing in an area where the radio signal
is weak. Stereo reproduction on AM
is not available.
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
CONTINUED
TUNE
Preset
SEEK
Operating the Radio
Audio System
Comf ort and Convenience Features
3.5 RL without Navigation System
129
01/09/28 19:45:42 31SZ3660_132
Main Menu Table of Contents