Acura 2002 RL - Owner's Manual - Manual (Page 268)

To remove the front turn signal/
parking light bulb, push it in
slightly and turn it
counterclockwise. To remove the
side marker bulb, pull it straight
out of its socket.
Install the new bulb into the
socket.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the inner fender cover back.
Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender. If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
Put the inner fender cover in place.
Install the holding clip. Lock it in
place by pushing on the center.
Test the lights to make sure the
new bulb is working.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
1. 2.
3.
4.
5.
6.
7.
8.
9.
Lights
Maintenance
Replacing Front Turn Signal/
Parking and Side Marker Light
Bulbs
265
H H O O L L D D I I N N G G C C L L I I P P
01/09/28 20:08:43 31SZ3660_268
Main Menu Table of Contents