Acura 2005 RL - Owner's Manual - Manual (Page 64)

This indicator normally comes on for
a few seconds when you turn the
ignition switch to ON (II). This indicator has three functions.
It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page
).
This indicator normally comes on for
a few seconds when you turn the
ignition switch to ON (II). For more
information, see page
.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should flash.
If it comes on and stays on at any
other time, or it does not come on
when you turn the ignition switch to
ON (II), there is a problem with the
VSA system. You will also see a
‘‘CHECK VSA SYSTEM’’ message
on the multi-information display (see
page
). Take your vehicle to a
dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have VSA
traction and stability enhancement.
For more information, see page
.
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
1.
2.
3.
281
281
76
281
316
76
Instrument Panel Indicators
Vehicle Stability Assist
(VSA) System Indicator VSA Activation Indicator Turn Signal and
Hazard Warning
Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
63
Main Menu Main Menu Table of Contents