Acura 2005 RL - Owner's Manual - Manual (Page 206)

CONTINUED
Unplug the garage door opener
motor from the electrical outlet.
Hold the end of the garage door
opener remote 2 to 5 inches from
HomeLink. Make sure you are not
blocking your view of the red
indicator in HomeLink.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 5.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitter may stop
transmitting after a short time.
Go to step 4.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 5.
If the red indicator in HomeLink
continues to flash slowly (does
not begin to flash rapidly),
repeat steps 2 thru 4.
Plug in the garage door opener
motor, then test the HomeLink
button by pushing it for about 1
second.
If the indicator flashes rapidly
for 2 seconds then stays on, you
have a rolling code transmitter.
Go ‘‘Training with a Rolling
Code System’’ (see page
).
If the indicator stays on or
flashes slowly, repeat steps 2
thru 5.
Push and hold the HomeLink
button for a few seconds, then
watch the red indicator on
HomeLink.
If the button does not work go
to step 6.
If the button works,
programming is complete.
2.
3.
4.
1.
5.
6.
206
HomeLink Universal Transceiver
Fe
a
tu
re
s
205
RED
INDICATOR
Main Menu Main Menu Table of Contents Table of Contents