Acura 2005 RL - Owner's Manual - Manual (Page 174)

The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the AM/FM button (AM or FM
button on Canadian, Alaskan and
Hawaiian models). You can also
change bands by pushing the
interface selector up. Each time you
push it up, the band will change to
FM1, FM2, or AM. On the FM bands,
STEREO will be shown on the
navigation screen and ST on the
upper display, if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
Use the TUNE button to
tune the radio to a desired frequency.
Press the
button to tune to a
higher frequency, or the button
to tune to a lower frequency. To tune
with the interface dial, push the
selector down, and turn the knob to
TUNE. Then press ENTER on the
selector, and turn the knob to the
desired frequency. To exit the
TUNE mode, press ENTER on the
selector. You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and .
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Press the AUDIO button to view the
audio control display. Turn the
system on by pressing the power/
volume knob or the AM/FM button
(AM or FM button on Canadian,
Alaskan and Hawaiian models).
Adjust the volume by turning the
power/volume knob.
CONTINUED
TUNE To Play the AM/FM Radio
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
Playing the AM/FM Radio
Fe
a
tu
re
s
173
STEREO ICON
TUNE ICON
BAND
Main Menu Main Menu Table of Contents Table of Contents