Instrument panel indicators – Acura 2007 RDX - Owner's Manual User Manual
Page 74
It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
This indicator has three functions: This indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button (see
page
).
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages
and
).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
This indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control.
This indicator comes on with the
high beam headlights. For more
information, see page
.
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page
).
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. See page
for more
information on the VSA system.
1.
2.
3.
On RDX with Technology Package
model
Instrument Panel Indicators
VSA Activation Indicator
Cruise Control Indicator
Turn Signal and Hazard Warning
Indicators
Cruise Main Indicator
High Beam Indicator
70
Main Menu
Table of Contents