Acura 2007 RDX - Owner's Manual - Manual (Page 206)

The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the PWR/
VOL knob or the AM/FM button
(AM or FM button on Canadian
models). Adjust the volume by
turning the PWR/VOL knob.
To tune with the interface dial, press
the AUDIO button to view the audio
control display, then push the
selector down, and turn the dial to
TUNE. Then press ENTER on the
selector, and turn the dial to the
desired frequency. To exit the
TUNE mode, press ENTER again.
XM satellite radio information is
available on page
.
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, the
preset buttons or icons, and AUTO
SELECT.
Use the TUNE/FOLDER
bar to tune the radio to a desired
frequency. Press the
side of the
bar to tune to a higher frequency,
and the
side of the bar to tune
to a lower frequency.
If you press and hold the or
side of the bar, the frequency
will begin to change rapidly. It will
stop when you release it.
The band and frequency the radio
was last tuned to are shown on the
upper display. To change bands,
press the AM/FM button (AM or
FM button). You can also change
bands with the interface dial. Press
the AUDIO button to view the audio
control display and the band changes
to FM1, FM2, or AM each time you
push the selector up. On the FM
bands, ‘‘STEREO’’ will be shown on
the audio control display. ‘‘ST’’ will
also appear on the upper display if
the station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
221
On U.S. models
Audio System
To Select a Station
TUNE
202
TUNE ICON
Main Menu Table of Contents