Acura 2008 TL - Owner's Manual - Manual (Page 233)

Compass operation can be affected
by driving near power lines or
stations, across bridges, through
tunnels, over railroad crossings, past
large vehicles, or driving near large
objects that can cause a magnetic
disturbance. It can also be affected
by accessories such as antennas and
roof racks that are mounted by
magnets.
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
Press and hold the and
buttons simultaneously until
the temperature display changes
(about 5 seconds).
Verify the zone for your area on
the map on page
.
Press the button to cycle the
count down, or the button to
cycle the count up. Once the
correct zone is displayed, continue
to step 4.
Press the OFF button to save the
zone selection.
To exit the zone setting mode,
either press the
button and
button simultaneously for
about 5 seconds, or press any
climate control button on either
side of the display other than the
or button.
1.
2.
3.
4.
5.
232
On models without navigation system
Compass Operation
Compass Zone Selection
Compass
230
2008 TL
Table Of Contents Main Menu